[[Include(WikiToC)]]

= Mobile PAAM OFDM =

=== Description ===

In this tutorial, we demonstrate an OFDM link with two mobile PAAMs, each consisting of an [https://wiki.cosmos-lab.org/wiki/Hardware/SubSystems/IBM#IBM28-GHzPhasedArrayBoardForCOSMOS IBM 28 GHz phased array antenna modules (PAAMs)] and a USRP-2974 SDR. When not in use outdoors, mobile PAAMs are accessible in [https://wiki.cosmos-lab.org/wiki/Architecture/Domains/cosmos_sb1 sb1]. This tutorial is based off the following demo in MobiCom 2024.

* P. Maddala, J. Kolodziejski, A. Adhikari, K. Hermstein, D. Chen, L. Zhu, T. Chen, I. Seskar, and G. Zussman, “Demo: Experimentation with Mobile 28 GHz Phased Array Antenna Modules”, in Proc. ACM MobiCom’24, Washington D.C., Nov. 2024 

Author: Kevin Hermstein, Columbia University (klh2179@columbia.edu)

Lst updated November 15th, 2024

=== Prerequisites ===

In order to access a COSMOS sandbox, create a reservation and have it approved by the reservation service. Access to the resources is granted after the reservation is confirmed. Please follow the process shown on the COSMOS getting [https://wiki.cosmos-lab.org/wiki/GettingStarted started page] to get started.

=== Resources Required ===

Two mobile PAAMs.

=== Tutorial Setup ===

Follow the steps below to gain access to the sandbox console and set up nodes with appropriate images.
 1. If you don't have one already, sign up for a [https://www.cosmos-lab.org/portal-2/ COSMOS account]
 1. [wiki:/GettingStarted#MakeaReservation Create a resource reservation] on COSMOS SB1
 1. Login to sandbox console ({{{console.sb1.cosmos-lab.org}}}) with four SSH sessions. (One session for array control, one session for GNURadio for each mobile PAAM)
 1. Make sure all the nodes and devices used in the experiment are turned off.
    {{{#!shell
    omf tell -a offh -t mob4-1,mob4-2
    }}}
 1. Use the {{{mob-paam-ofdm-tutorial.ndz}}} node image with Ubuntu 20.04, UHD 4.1, gnuradio 3.9, and a grc example used in this tutorial. Load {{{mob-paam-ofdm-tutorial.ndz}}} onto each mobile PAAM. Run each command in a separate session so they run in parallel.
    {{{#!shell
    omf load -i mob-paam-ofdm-tutorial.ndz -t mob4-1
    }}}
    {{{#!shell
    omf load -i mob-paam-ofdm-tutorial.ndz -t mob4-2
    }}}
 1. Turn all the required resources on and check the status of all the resources.
    {{{#!shell
    omf tell -a on -t mob4-1,mob4-2
    }}}    
    {{{#!shell
    omf stat -t all
    }}}
 1. {{{ssh}}} to each mobile PAAM with option -Y for using GUI with gnuradio. In the other two sessions, the -Y can be omitted.
    {{{#!shell
    ssh -Y root@mob4-1
    }}}
   {{{#!shell ssh -Y root@mob4-2
    }}}
At this point, you should have 4 sessions open. 2 {{{ssh}}} sessions connected to {{{mob4-1}}} and 2 connected to {{{mob4-2}}}. At lease one session for each must be initialized with {{{-Y}}} to enable the GNURadio GUI.