Changes between Version 8 and Version 9 of Hardware/FR3

Timestamp:

Aug 16, 2025, 10:44:06 AM (3 weeks ago)

Author:

seskar

Comment:

—

Hardware/FR3

@@ -30 +30 @@
  * High LO Frequency (GHz) — sets the “high-side” LO.
 Use the numeric box for fine increments and the slider for coarse moves. Together, these LOs place the desired FR3 RF channel while keeping IF in the supported sub-6 GHz range.
+
   [[Image(pi-frequency.png, 600px)]]
 
 * Filters panel: Per-chain drop-downs select the active RF/IF path for RX0, RX1, TX0, and TX1. The bypass option routes around the filter network; select a non-bypass entry to engage the appropriate bandpass path for that chain.
+
   [[Image(pi-filters.png, 600px)]]
 
@@ -38 +40 @@
   [[Image(pi-gain.png, 600px)]]
 
-* LO Supression: DC bias trims for the I and Q paths on each TX chain (TX0 I/Q bias, TX1 I/Q bias, in volts). Small adjustments here null residual LO feed-through and balance IQ, reducing the tone at the carrier when the transmitter is idle. Start near 0 V and sweep slowly while observing the carrier leakage. 
+* LO Supression: DC bias trims for the I and Q paths on each TX chain (TX0 I/Q bias, TX1 I/Q bias, in volts). Small adjustments here null residual LO feed-through and balance IQ, reducing the tone at the carrier when the transmitter is idle. Start near 0 V and sweep slowly while observing the carrier leakage.
+ 
   [[Image(pi-suppression.png, 600px)]]
 
@@ -46 +49 @@
   * Disable Input 20 dB Attenuator — toggles the on-board input pad; uncheck to insert 20 dB of protection when measuring strong signals.  
   * Reset LMX button — re-initializes the LO synthesizer(s) to recover from configuration changes.
+
   [[Image(pi-control.png, 600px)]]