This tutorial contains instructions for running the openairinterface eNB and UE on various platforms.

Prerequisites

1. Two nodes, with appropriate hardware, within RF range
2. Currently supported: USRP x310, USRP 2974, USRP b210
3. Load the image omf-baseline-oai-1804.ndz onto both nodes
4. Turn the nodes on
5. If graphical display is desired, enable x11 tunneling to console and then to nodes

On node 1

1. run /opt/oaiscripts/build_oai.sh to build for the current hardware and kernel
2. edit the file /opt/oaiscripts/run_enb.sh for the SDR in use, for example, set SDR IP addr and max gain
3. run /opt/oaiscripts/run_enb.sh

On Node 2

1. run /opt/oaiscripts/build_oai.sh to build for the current hardware and kernel
2. edit the file /opt/oaiscripts/run_ue.sh for the SDR in use, for example, set SDR IP addr and max gain
3. run /opt/oaiscripts/run_ue.sh