Changes between Version 37 and Version 38 of Tutorials/Wireless/mmwave Paam Basics

Timestamp:

Mar 10, 2022, 6:39:13 PM (3 years ago)

Author:

prasanthi

Comment:

—

Tutorials/Wireless/mmwave Paam Basics

@@ -182 +182 @@
 }}}
 
-* Similarly, start PAAM #2 (rfdev4-in2) in TX mode with V-polarization using 16 antenna elements on all the ICs, and configure the TX beamforming direction to be in the broadside (0,0). Check the current consumption to make sure the ICs have been successfully initialized.
+Similarly, start PAAM #2 (rfdev4-in2) in TX mode with V-polarization using 16 antenna elements on all the ICs, and configure the TX beamforming direction to be in the broadside (0,0). Check the current consumption to make sure the ICs have been successfully initialized.
 {{{#!shell
 root@console:~# curl "http://am1.orbit-lab.org:5054/array_mgmt/configure?dev_name=rfdev4-in2.sb1.cosmos-lab.org&ics=all&num_elements=16&txrx=rx&pol=v&theta=0&phi=0"
@@ -227 +227 @@
 
 ==== Observe the results ====
-The left figure shows the frequency response of the received tone at 1MHz offset.  
-[[Image(mmwavePaamBasicsFreq_n_4.png, 600px)]] 
+Figure below shows the frequency response of the received tone at 1MHz offset.  
+|| [[Image(mmwavePaamBasicsFreq_n_4.png, 600px)]] ||
 
 ==== Finish the experiments ====