Changes between Version 1 and Version 2 of testing/asE312

Timestamp:

Apr 8, 2019, 5:08:32 PM (6 years ago)

Author:

nilanjan

Comment:

—

testing/asE312

@@ -1 +1 @@
 == Antenna Setup/Installation/Deployment Validation ==
 
-Attahc E312 to the large sector antennas to test cabling; cover GPS and each of the pannel antennas.
+Attach E312 to the large sector antennas to test cabling; cover GPS and each of the panel antennas.
 
 
@@ -153 +153 @@
 }}}
 
-Output if antenna is working fine:
+
+To use the E312 for antenna testing press and hold the power button for a second and release. Give it about a minute for start up. In this time frame the leds above the antenna ports should light up briefly but only the led above the transmit antenna will remain on once the applications are launched. 
+
+Output from transmit antenna on E312 is working fine:
 
 [[Image(sa-output.png, width=200)]]
 
-Transition from all 0 to GPS coorinates in teh log file on the flash drive (filename based turn-on timestamp)
+The ''tx_waveforms'' application generated the above signal. The application is with run options for a 1KHz RAMP signal centered at 2440 MHz and a 100 dB gain.
 
+GPS output will be logged into file stored on flash drive. Log file name will have timestamp of when the device was turned on and the path to this log file will be /mnt/cadv-{timestamp}.log. This log file should be populated with raw NMEA sentences containing the GPS coordinates with a corresponding timestamp.
+
+Transition from all 0 to GPS coordinates in the log file will happen once GPS is synchronized with satellites.  
+